EasyShort – Mobile Prosthetic Solution

All the abutments, analogues and transfers are made of Grade 5 titanium (Ti6Al4V). The fastening screw fixing ELPSC1 is included in the packaging of the abutments. Tighten to 30 N*cm using the torque ratchet wrench ELPSK1 or ELPSK2 with the torque ratchet ELKWD.

Ball abutment for mobile prosthesis

Code Height(mm) Ø Ball mm
ELSAP 0.0 2.5
ELSAP1 1.0 2.5
ELSAP2 2.0 2.5
ELSAP4 4.0 2.5

Tighten to 30 N*cm using the torque ratchet wrench ELSAPK
with the torque ratchet ELKWD.


 

O-ring holder

Code Ø Ext(mm) H mm
ELGOR 5.5 2.4


 

Silicone O-ring

O-ring-in-silicone

Code
ELOR


 

Normo Clear Elastic Retentive Cap (standard retention)

Code
040CRN


 

Normo Pink Elastic Retentive Cap (soft retention)

Code
040CRNSN


 

Normo Yellow Elastic Retentive Cap (extra-soft retention)

Code
060CRNAY


 

Stainless Steel Housing Normal Size

Code
041CAN


 

Protective Disk

Code
100PD


 

Ball abutment analogue

Code
ELSAPA


 

Implant analogue

Analogo-impianto-dip

Code Colour For implants
EDAN Gold Ø 3.5 & Ø 4.0 mm
ENAN Green Ø 4.75 & Ø 5.25 mm

 

Implant transfer

Transfer-per-impianto-dip

Code Colour For implants
EDTRA Gold Ø 3.5 & Ø 4.0 mm
ENTRA Green Ø 4.75 & Ø 5.25 mm


 

Impression transfer technique for the EasyShort® implant

To transfer the location of the fixture onto a casting, proceed by inserting the implant transfer EDTRA or ENTRA in the implant and secure it with the long fastening screw ELPSC2 included in the packaging of the transfer. Tighten using the screwdrivers ELCSK1 or ELCSK2 or the contra-angle wrench ELPSCAK. Then proceed with the impression using a slotted spoon. Before removing the impression, loosen the fastening screw releasing the transfer. Insert the implant analogue EDAN or ENAN, assembling it to its transfer EDTRA or ENTRA using the fastening screw previously loosened. Now it’s possible to send the impression to the laboratory.

Impression transfer technique for ball abutment

To transfer the location of the ball abutments for mobile prosthesis, proceed by screwing abutments themselves with a torque of 30 N*cm, using the torque ratchet wrench ELSAPK inserted into the torque ratchet ELKWD. Take a traditional impression with a traditional spoon and place in the impression the analogues of the ball abutments ELSAPA. Send the impression to the laboratory.