EasyRapid – Screwed Prosthetic Solution

All the abutments, analogues and transfers are made of Grade 5 titanium (Ti6Al4V). The fastening screw ELPSC1 is included in the packaging of the abutments. Tighten to 30 N * cm using the torque ratchet wrench ELPSK1 or ELPSK2 with the torque ratchet ELKWD.

Octagonal abutment

moncone-ottagonale
Code
ELMEO

Tighten to 30 N*cm using the torque ratchet wrench ELSAPK
with the torque ratchet ELKWD.

 

Castable for octagonal abutment

Calcinabile-del-moncone-ottagonale

Code Indication
EDCEOC For circulars
EDCEOE For mono implants


 

Esthetical octagonal abutment

ELMEO3

Code Height (mm)
ELMEO15 1,5
ELMEO3 3.0
ELMEO4 4.0


 

Titanium cap for esthetical octagonal abutment

Code
ELMEOC


 

Castable cap for esthetical octagonal abutment

Code
ELMEOCC


 

Analogue for octagonal abutment

Analogo-del-moncone--ottagonale

Code Colour
EDAMEO Gold


 

Transfer for  octagonal abutment

Transfer-del-moncone-ottagonale

Code Colour
EDICE Gold


 

 

Implant analogue

Analogo-impianto

Codice Colour
EDAN Gold

 

Implant transfer

Transfer-per-impianto

Code Colour
EDTRA Gold

 

Impression transfer technique for the octagonal abutment

To transfer the location of the octagonal abutment onto a casting, proceed by inserting the transfer for octagonal abutment EDICE or ENICE and secure it with the long fastening screw ELPSC2 included in the packaging of the transfer. Tighten using the manual screwdrivers ELCSK1 or ELCSK2 or the contra-angle wrench ELPSCAK. Then proceed with the impression using a slotted spoon. Before removing the impression, loosen the fastening screw releasing the transfer. Insert the implant analogue for octagonal abutments EDAMEO or ENAMEO, assembling it to its transfer EDICE or ENICE using the fastening screw which has been previously loosened. Now it is possible to send the impression to the laboratory.

Impression transfer technique for the EasyRapid® implant

To transfer the location of the fixture onto a casting, proceed by inserting the implant transfer EDTRA or ENTRA in the implant and secure it with the long fastening screw ELPSC2 included in the packaging of the transfer. Tighten using the screwdrivers ELCSK1 or ELCSK2 or the contra-angle wrench ELPSCAK. Then proceed with the impression using a slotted spoon. Before removing the impression, loosen the fastening screw releasing the transfer. Insert the implant analogue EDAN or ENAN, assembling it to its transfer EDTRA or ENTRA using the fastening screw previously loosened. Now it’s possible to send the impression to the laboratory.